Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

EEM script to poll next hop interface

Hi AllI am new to EEM scripting and would like some help. Please refer to the attached diagram and the scenario below : CPE has 2 up links as shown on the diagram connecting to the ME3400 (layer 2 path) devices on each link and then the 3400s connect...

mmoraba by Cisco Employee
  • 1393 Views
  • 6 replies
  • 0 Helpful votes

Cisco CCP 2.8 trouble

I have Windows 2012 R2 Server(No roles installed).I installed Cisco CCP 2.8 successfully and run also.it is working I finished every thing required including Java Runtime 1.6.0_11,Flash Player 10/11I also configured Internet Explorer 11 security sett...

Resolved! Prime 3.0

Hi,I'm using PI 3.0 since a few hours. Now I try to run eox report, but I'm not able to configure the settings. Exact version is 3.0.0.0.78I used this link, Administration / Settings / System Setting. I'm looking for compliance enable, but I can't se...

Cisco Prime eMail Alerts

Hi I am new into PrimeHow can I make a custom mail alert when a port goes into blocking state, when there is a MAC flapping between ports, when there is any hardware failure, when there is a configuration change ?For now I only get emails when a devi...

Change password via SNMP

I have Wireless Lan Controller AIR-CT2504 with some APs. When I get any SNMP value from it all is fine:# snmpwalk -v2c -c private wlan-ctl 1.3.6.1.4.1.9.9.521.1.1.1.1.8.4SNMPv2-SMI::enterprises.9.9.521.1.1.1.1.8.4 = STRING: "*********"But when I try ...

olddanmer by Beginner
  • 2092 Views
  • 2 replies
  • 0 Helpful votes