Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Cisco Prime Infrastructure 2.1

HI All,Hopefully a very easy question that i cannot get to the bottom of - VG224I am trying to push out an snmp-server location to all my devices in Prime. The devices seem to accept the config but in the menu i cannot select the VG224's as devices t...

Factory reset wap321

HiCan anyone please tell me how to reset the admin user and admin password on the cisco wap321. Have tried to hold the reset button until the lights turn off and the standby light comes back again.Thanks

Resolved! Topology View / Service with Cisco Prime Infrastructure 2.x "PRIME-NCS-APL-K9" ????

Hi Team, Hope you all doing well. I just want know few thing about Cisco Prime Infra 2.x. 1st thing is does CPI2.x support Network topology View? if not then is that any other feature which can provide Network View (exa :- Map,etc)?2nd thing is it po...

NCS 1.0.2.29 to Prime 2.2 path

HiIv got a task to upgrade a NCS 1.0.2.29 to a Prime 2.2. When going through the different release notes from NCS 1.0.2.29 and all the way up to Prime 2.2. I found the following path:NCS 1.0.2.29 to Prime 1.2.1.12Prime 1.2.1.12  to Prime 1.4.0.45Prim...

Resolved! I need a script to monitor bandwidth on port-channel interface and change the shape bw in qos policies accordingly. Any sample?

On a port channel (Etherchannel) the bandwidth changes based on how many links are in up state. The QoS shaper bandwidth on port channel sub-interfaces (VLAN's) need to be adjusted accordingly.I'd like to have a script for IOS routers that runs every...

mamikhai by Cisco Employee
  • 1880 Views
  • 2 replies
  • 0 Helpful votes

Resolved! LMS 4.2 RMEDbEngine do not start

Hello,since a few days I have a problem with my LMS 4.2.5. In the section software/hardware Summary i get only the message: "No devices in LMS (or) Unable to retrieve devices with inventory data."In the Job Approval section: "Not able to intialize Da...

Resolved! VPN monitor script

We have 819 4G routers and I am after a script to monitor the VPN tunnel is always alive. - ping a remote server, ie 172.16.1.1 and if it times out, but the pings to 8.8.8.8 are still live, to only shutdown and enable the site-to-site vpn. I have loo...

sprocket10 by Explorer
  • 1119 Views
  • 1 replies
  • 0 Helpful votes

Cisco-Prime 2.1

Hi Team,We are running with Cisco prime  appliance(hardware)2.1 version  and we found many bugs in the versions.so we planned to upgrade the Prime appliance to 2.2 version .and we have taken the prime appliance back in the local drive of the disk of ...