Network Management

Hello,  I registered couple of tcl scripts in ASR 9k event manager. But, after few days, the event manager automatically unregister the scripts. It also generate some error logs. eem_policy_dir[201]: Can not get the event Description: 'Embedded Even...

Hello! We are trying to export netflow data from our Cisco 3850-24XS-switches to a lancope flow collector but seem to have some issues with this. We are using software version 03.07.03E and the following netflow configuration flow record IXNF01 matc...

Hello whats the different between ( clear cable modem(mac) reset   and    clear cable modem (mac) delete) ?

Hello - I am using Cisco Prime Infrastructure to archive my device configurations nightly.  However, my 2900 ISRs fail to archive when 'ip ssh dh min size 2048' i s applied.  I several Catalyst 2960XR switches with this set and can archive with no is...

We recently enabled NAC enforcement with 802.1X and ISE. Off of one of our many switches, the 69XX and 79XX phones will unregister when the PC connected inline is logged off.  Does anyone have any insight into this issue?

Tech_pack is shown as installable, but installation stops with error, manual upload is also not working. Errormessage: This error is often caused by discrepancies between what is downloaded and the attributes of the files which were expected. Reason...

Hi all, I'am new to Cisco Forum and I hope my question is in the right section. I'am 21 years old and I'm currently studying Informatics. For my final exam I do a Zero Touch project. I'm trying to find out how to provision a Switch with a DHCP and a ...

Hi Board, I'm using Prime Infrastructure 3.1 in combination with AireOS WLCs (version 7.6). Prime has SNMP read and write access to the WLCs as well as CLI credentials via SSH. As soon as the WLCs are added to Prime (either manually or automatically)...

Seek advice on automating (scheduling) detection of unsaved configs. Say, running config is archive is > 24h old and it is still different to startup config. Is there a way to get an alert for similar condition with PI 3.1 ? Essentially, the purpose ...