Network Management

Hi, I updated our Prime from 3.7 to 3.10. We built a new VM for 3.10. I followed the quick start guide to set up the VM, admin & root passwords. I also copied over the old 3.7 backup into 3.10 & it loaded successfully. (as the quick start guide said ...

I cannot run multiple commands on IOS from SSH batch file -it thinks my file is one command only,however the same file works on the PIX; do they behave differently or am I missing something ?eg: commands.ssh (DOS encoded) for PIX:enablesomethingshow ...

After i upgrade the switch to latest firmware version 1.4.11.5 from  1.4.5.02, the switch had reboot 2 time within 2 week, both is on Friday morning, but there is no schedule reboot in switch or UPS. Anyone can advice regarding this issue?

Hi I try to configure netflow on our internet router. Below you see which configuration I try.The target is, that the netflow data goes over the management interface to our PRTG server. The management interface is in vrf Mgmt-intf. After the configur...

So, I have a Cisco phone that isn't registering. Worked before. Nothing in the configs has changed. It works in other ports just fine, it's just this one. I can see the MAC when doing sh cdp neigh. I can see traffic. I do not see any errors. Just a l...

Hello gods of tech.One can configure load-balancing within switches, routers, firewalls, and specific load-balancing hardware such as F5 brand devices.Is the reason most deployments use specific load-balancers because of the administrative ease of us...

When I try to connect to my switch I get this error$ ssh cisco@192.168.7.203 Unable to negotiate with 192.168.7.203 port 22: no matching key exchange method found. Their offer: diffie-hellman-group-exchange-sha1,diffie-hellman-group1-sha1And I just d...

Hi everyone,I have two Cisco Prime Servers. It was running okay. Until primary switched to the secondary as operational.Version: 3.9 (3.9.0.0.219)Now I see this error:Check Failback Readiness: FailedSYSTEM - CHECK DISK IOPS = Test is successfulNETWOR...

So, we were testing some things in the IT lab today, things we didn't think would do any harm on a live production environment. Well, we were wrong. lol We have it back up now, but I can't stop wondering WHY adding a VLAN (the subnet our CME is in) t...

I am about to configure new voice VLANs for our new phone rollout. Before I configure them, I wanted to make sure WHERE I need to configure them. Do I have to configure new VLANs on the core switch or does it matter? 

Hi Evryone,please help how add attribute huawei CIR in and out in the device Cisco Access Registar ?

Does anyone know why it doesn't ping 8.8.8.8 in Cisco Modeling labs (ACL). configure interface g0/0 as DHCP and take an ip 192.168.255.67 but it does not go to the internet 

Good afternoon everyone, yesterday I tried to do a lab to test NAT but it doesn't work for me, any recommendation?The pc takes ip from vlan 20///ROUTER//Router>enableRouter#confiRouter#configure tEnter configuration commands, one per line. End with C...

Does anyone know what is OID to get envmon information for nexus93 NXOS?  i can get result envmon result from C9500 as follows, but i am not able to get any result from nexus93.  cisco 9500:xxxx:~$ snmpwalk -v2c -c public 192.168.10.1 .1.3.6.1.4.1.9....