Network Management

Cisco ise is running version : 1.3.0.876 A configuration backup was launched using the GUI towards a external repository. When this backup failed, the cancel button was hit. But since then the task hangs in a cancel state (already several days). NPSO...

Hi all We currently have Prime Gen1 appliance running v2.2 We also have a new virtual appliance  I am struggling to establish whether it's possible to take a backup from v2.2 and restore into v3.1. Can somebody confirm if this works?  Thanks James

In our environment the IP address of Prime (which resides in our internal network) is translated to a different address for devices which resides on the external networks. When you make a configuration backup or image upgrade for example, at a certai...

Hi team! Need your help in fine tuning EEM. 025951 is registered to registrar1 and 036751 to registrar2 everything works fine...exept SIP registration 025951 could be dropped ... suddenly, without any reason ssip - alias to "sh sip-ua register status...

Hello I'm looking at getting Prime Infrastructure 3.1.0.0.132 configured to send out emails when a link goes down on a Core or Distribution switch but not when a link goes down on an Access switch (100s of switches and 1000s of interfaces) Core, Dist...

Hi, Archive Configuration We performed weekly backup and noticed that a previous backup of some network devices are overwritten instead of retaining them. For example, the backup today has overwritten the backup that was made in 9/2. On-demand back...

Hi, Currently, we are running Cisco Prime Infra running on 3.0.3 on Virtual appliance.We have many cases pending from Cisco TAC like : 1)Snmp connectivity failed issue. 2)Partial collection failure. 3)Low disk space. 4) Some report related isues. He...

I am working on the configuration of the NAM to address Application Response Time. Hereby I am running into some issue. The latest PP is installed and Deep Packet Inspection. I still have a lot of unknow traffic and I do not really understand how to ...

Hello to allyou can load the MIB to third-party products that Cisco Prime 3?How do you do? I telesin of allied that I can not handle ....Thank you

In Prime users guide there is section describing 'Creating NAT IP Pools': Step 1 Choose Inventory > Device Management > Network Devices. Step 2 After choosing the device from the list, click Configuration. The Feature Configuration pane appears. Ho...

Good morning. I have a new project in the work, i need equipment for a medium enterprise, i´ve seen many equipment in the web page Cisco, however i do not understand the paragraph "End-of-Life and End-of-Sale Notices".The equipments that at present ...

Hi Folks,    I'm looking for a script that can run traceroutes to multiple IP addresses. I could only find script for ping which works absolutely fine, but need one for trace. Any help will be much appreciated. Thanks Prav

Hi,I would like to know how to1. Upgrade Cisco Prime Infrastucture 2.1.1 to 2.2 procedure2. How to backup existing config and data Thanks in advance- nazir