Network Management

Hi I need to make a change, where when i enter the first command, i lose remote connectivity where i need to enter a few more commands. Is there a way i can script this? Im trying to make the changes to some ports on a 3850.Im doing some python scrip...

I'm spinning up a new install of PI2.2. I've patched the install and i'm trying to apply the "Data Center Technology Pack". I've already installed the "Wireless Technology Pack" so when I go to install the DC pack it states an error that "More than o...

Are there any recommendations, or things to look for, to correct udp jitter probes returning zero one way latency values? What are the determining factors for  NTP to be out of spec for instance? Documentation on Cisco's site is very vague, curious t...

Hi Community,I am trying to execute the following script by using EEM and it is failing due to the line 30 command requesting an answer. What do I need to do to either reply yes to the question or force the cli to continue without asking the question...

We have a pair of Nexus 3500 switches. We are monitoring them using Prime Infrastructure 2.1 using snmpv3. Prime sees the switches fine and is able to show information on them. I have some 2960X's configured using snmp v3 and they are sending traps t...

Hi i am using Cisco WS-C3560G-48TS SW Version: 12.2(44)SE6    System image file is "flash:c3560-advipservicesk9-mz.122-44.SE6.bin"Router bgp limitation is  <1-65535>  Autonomous system numberbut i need to set the bgp 134084 when i try to set 134084 i...

Hi,I currently have a Cisco 6509 router containing a couple of WiSM2 modules in it. I'm looking for a way to configure the 6509 to send SNMP traps whenever a log entry is added regarding the WiSM2 modules.For example:%WiSM-5-STATE: Controller 1 in sl...

We have several 6500 routers within our network for which we need to deploy EEM scripting.I have noticed that the version of EEM script is below (or equal to) Version 2.40.We need to use the string command. However we get the following output: Router...

I have a customer who I have to upgrade the PI from 2.0 to 2.2. Can this be done remotely and can I go straight from 2.0 to 2.2 or do I need to go to 2.1 first? Assistance would be greatly appreciated.

Hello ,I can't configure management port on cisco 3850 .I want to be able to assign an ip and remote in via ssh or telnet to turn ports on and off.I didnt find any documentation about it.Thoughts?

I ran CNA 5.5 up until last week when Java 7 71 update hit. When I tried to launch, I received JVM Not Found, that was all. So I figured it was time to install CNA 6, however during the install process I now get a pop up box stating  InstallShield Wi...