Network Management

Hello, How is migrated assurance license from one to other device? For example, I deleted flow config from ASA but it stays in Device Data Source. Also Last Active Time does not increase. The number of used assurance licenses remains the same. The de...

I am needing an external ringer for the Cisco IP Phone 7962..its to enhance the ring so that we may hear it in the warehouse.

Hello, I'd like to monitor OTV related stuffs on ASR1001x. I've downloaded CISCO-OTV-MIB but it seems to my it is not supported on ASRs. Is there any way how to monitor OTV on ASRs using SNMP? Thanks Petr

Dear Experts, I am planning to add  Cisco prime to my infrastructure, which also have Palo Alto Firewalls. In the supported devices list for Cisco prime, I don't see any mention of Palo Alto devices. Could some one please confirm if we can integrate...

Hello Guys;    Is there a way to disable FIPS mode on a newly installed Cisco Prime Infrastructure 2.2? Thanks for your support.  Regards, 

Hi Currently, I am using windows 2008 to act as radius server for the network equipment, but I am stuck in the cisco WLC 5508. The situation is that I am able to login routers, switches, wireless clients with using the radius server. For the WLC, I c...

Hello All, We need to enable card down trap on cisco 7k switches to send it to HP NNM (NMS) server so that when there is issue with card ,NNM identifies it. Now once card down trap is enabled on switch , i have to enable snmp trap configuration on (...

When trying to answer questions about which cable is connected to which port on my asr9k, I'm struggling to figure out how to show the mac address on the other side of a port for identification purposes.

Do the SNMPv3 requires defining views? As far as I understand with views you can restrict what the SNMP user can access. What is the behavior by default? What if I define only a group and a user? What access do the user will have?

Hello, I have flexible netflow configured for ipv6 like this: flow record ipv6-hor-ror-router-1 match ipv6 traffic-class match ipv6 protocol match ipv6 source address match ipv6 destination address match transport source-port match transport destinat...

The script is triggered but  changing the ip nat source interface is not working.Any suggestions 

hi guys, i am planning to get a new SNS 3495 hardware with ACS software and based license, CSACS-3495-UP-K9 Upgrade to Cisco Secure ACS application software on the Cisco SNS 3495 appliance with Base license from previous versions   CSACS-3495-K9    ...