All,
I am running into issues when retrieving Hex-String Values from IOS switches with perl, snmp_utils perl module, and net-snmp. For example, when I walk the following OID 1.3.6.1.2.1.17.4.3.1.1 on a particular Vlan, my result is literally "180.20...
I would like to have eem applet to run say hourly and copy file ( something like below ),
I believe i may have an issue after action 1.0 as it results in the next line
as it would confirm destination file name and i would assume expect the enter po...
Does somebody know working grep command in IOS.sh ?I experience no output with TACACS+ Authorization, "show authentication sessions | grep -ie 'gi' " with a command authorization failure, the option -v never works, "show run | grep -i 'interface'" o...
Hi guys,
I am couple weeks old now with an attempt for an EEM script to catch a QoS event. I have setup a basic interface policer on the Internet line:
int_r2#show policy-map Policy Map BW_check Class class-default police cir 96000000 bc 3000000 con...
Dear All
I have Router (Cisco 2811), it was working fine and now i am not able to SSH/Telnet to this Device. While trying to telnet or SSH it says "connection timed out; remote host not reponding".
Please help with suggestion what could be the issu...
Hi All,
I am looking for a command to see the current tcam fib utilization on a 7200, NPE-G1 router like "show mls cef maximum-routes" that we use on 7600 platforms.
I have searched extensively on internet but couldn't find the required information,...
Team,
Is it difficult to write a script which performs a shutdown on a Cat3650 interface once attenuation has reached >17dB (29.5 is current in the output below)?
Thank you,
Switch#show interface transceiver
If device is externally calibrated, onl...
I am writing an EEM script that is supposed to remove itself under certain conditions. While it is able to remove itself, doing so generates an error.
As an illustration, I've tested a bare-bone TCL EEM policy called remove_me.tcl whose only goal is ...
Hey all, I need some help with the TCL scripting. I've deploying the TCL scripts to be triggered by an SNMP notification but they are not working; on the routers I have it installed on the TCL script doesn't kick off when it receives the trap.
Here ...
Hello Everyone,
We are planned to monitor ivr application through SNMP. Can anyone suggest me how to start with it. I need to develop own mib file consisting of possible errors like error.badfetch.http 404,element error,SQL exception etc......
I am migrating a single Prime Gen 1 appliance running 2.1 to a new pair of Gen 2 appliances running 2.2
At the same time I am migrating away from a lot of Wism modules to 5508 controllers.
So my thoughts are that I will install 2.2 on the Gen 2 ap...
We just purchased Cisco Prime Infrastructure 3.0 and want to login with our Active directory credentials, is that set up using our tacacs server? does anyone know of the procedure for getting this set up? we did it with Ciscoworks but that was a long...
