Network Management

I have a customer who is trying to determin if he needs two different netflow configurations to replace the v5 default he was running prior to needing to change to Flexible.  He is looking for recommendation regarding using one netflow for WAN interf...

Hi Experts, Users are unable to get authenticate when they connecte in extreme switches because of the below error 11051 RADIUS packet contains invalid state attribute. For cisco switches it is working fine without any issues. Whether ISE supports...

we want to disable client telnet to switch 1, how to do it?we also want to block IP 192.168.0.2--192.168.1.23 to logon to switch1, router 2 and voice gateway 1 management port, how to do in case of switch, router and VG? thanks

Hello, I'm getting something that looks not normal to me, while I see the memory usage dropping I notice that the process Licensing Auto U (which I assume Auto Update or something) is consuming a big part of it. Is this normal or something need to be...

Hi! I have SPA 2GE 7304, how do I configure the SFP ports? Does it have to be enabled? On show interfaces only the GigabitEthernet is showing. Please help. Thank you.

Hi there, I am currently using Solarwinds to monitor a network and it provides visitbility to interfaces being up\down, high cpu threash-holds, high throughput, etc. However I'm looking for more granular info such : 1) CRC errors on the interface 2) ...

Hi, I wanted to know if it was possible to power up a N2K-C2248 and be able to clear any pre-installed config from a previous N5K that had been previous connected to? We are trying to re-deploy Fex's on N5K's that are in production with a lower NX/...

So after battling for a while, I finally figured out that CCP only opens properly if I run it as an Administrator. My hopes were cut short again because the next problem I encountered was that when it opens, only a quarter of the browser screen is di...

Help me please with getting rid of the following error message:c1841#tclsh tftp://10.1.0.27/eemsample.tclLoading eemsample.tcl from 195.239.44.46 (via FastEthernet0/1): ![OK - 171 bytes]unknown namespace in import pattern "::cisco::eem::*"while execu...

I am new to networking in general, as such I don't really know what I am doing exactly.I logged into the SGE2000 web interface, and decided I wanted to start fresh by doing a factory reset, so I could learn how to setup the switch. Before doing so, I...

Hi, We have a need to ssh from a Cisco 3925 to a device which only supports the following hash algorithms: hmac-sha2-512  or hmac-sha2-512-96 hmac-sha2-256 or hmac-sha2-256-96 hmac-ripemd160 Can anyone advise on an IOS version where the SSH client su...

I am working on an applet that monitors my route table. I would like to have something like this: event tag E1 routing network 0.0.0.0/0 le 1 event tag E2 routing network 10.0.0.0/8 ge 16 event tag E3 routing network 10.1.0.0/16 ge 16 event tag E4 ...

Is this possible ?

We have a Cisco 2500 Wireless Controller ported into a Cisco switch. The dashboad interface on the controller does a wonderful job giving insight to the traffic on our 6 WAPs being utilized by our wireless clients, but I'm not sure if it is (or can) ...