Network Management

I'd like to block a particular MAC address from my network from 9pm to 7am, but entering these times gives the following error message: "Start time should be smaller than end time".  So I thought I would create one rule for 2100 to 1159 and another f...

Hi All,Can I configure SPAN to send traffic from more than 1 source ports to 1 destination interface (sniffer connected)?For example:monitor session 1 source interface Gi1/0/1monitor session 1 source interface Gi1/0/2monitor session 1 destination int...

Hi,  I would like to know why with devices with ios, in the network event label of cisco prime  network vision  you can see the source ip of the request in a authentication failure as following: so.org.dod.internet.mgmt.mib-2.system.sysUpTime.sysUpTi...

Hi,We have an ASR that regularly alerts us with messages such as:- 14,985 mV (Voltage 9006) is above the error limit of 12,599 mV- 4,995 mV (Voltage 9002) is above the error limit of 1,259 mVThe alert last for a few seconds only We use PRTG as our mo...

Hello, I have a client that is wanting to monitor CRC errors on a router's WAN interface. The client was attempting to use the ETHERLIKE-MIB, but this will not work. I was looking at the following: http://tools.cisco.com/Support/SNMP/do/BrowseOID.do?...

Hi everyone. After restarting the machine the RME module no longer works. After several researches I discovered that the problem may be in the CTM_config.txt file the following directories: CSCOpx \ MDC \ tomcat \ shared \ lib \ CSCOpx \ MDC \ tomcat...

Hi guys, We are trying to subscribe to events in Notifications API, but all we get is nothing. We are thinking that maybe the information we are filling in the NotificationReceiverInfo section of the request is not right.. Can you please help with a ...

Hi guys,All Im after is a definitive answer for the above question,is LMS 4.3.2 compatible with Server 2012,Moving from 2003 and don't want to run into any issues with the for mentioned version,Cheers in advanceMartyn

Last few days i had been exploring Cisco IOs Performance Monitor http://www.cisco.com/c/en/us/solutions/collateral/enterprise/enterprise-medianet/whitepaper_c11-653060.html for the use case “Application performance monitoring” After doing the configu...

I need help getting into my router settings i have a dpc3925 cisco router and I tried looking up the username and password for my type of router but none of the work I need to get.into my router settings because my xbox is on the list of the that are...

Hi , I have Cisco ASR9k running with NAT44 serviceI have some numbers to monitor that will be extracted using show | includeI want to write an EEM script that will take an action if this value exceeds a certain valueAs well , can I draw these value u...

So I have several hundred branch devices.. Cisco 2821's with an integrated switch module.  Each device is setup the following: 10.x.x.1 (router) and 10.x.x.2 (switch).  I want to update my NTP server statements on the switch to be the router IP (.1)....

So I'm very new to managed switches. I have just bought a used 2960-24tt-l but i can't seem to get express setup to work. It starts to blink like it's in express setup mode and i can access it on 10.0.0.1 through both CNA and http, but I'm sent to wh...

I had a query with respect to eem tcl scripts.I have to invoke a script when a customized syslog is generated, which is not workingTest1.tcl::cisco::eem::event_register_none maxrun 100namespace import ::cisco::eem::*namespace import ::cisco::lib::*ac...