Hi Experts,can somebody guide me for CA certificate installation & procedure for prime infrastructure.i'm newbie to prime infrastructure.any help appreciated ?
How do you define an acceptable throughput? or how to calculate an acceptable throughput? Let's say I have a router with an average throughput of 47 Mbit/s. When 8 users are simultaneously downloading a 700 MB file, the average throughput drops to 6 ...
We have implemented Cisco Prime Infrastructure 2.2 in our facility. We have each switch loaded in with an "snmp-server location" set for the switches for easier identification and quicker troubleshooting. We would like that location to show in the ...
I have port security enabled on most of the ports in my organization, but I am running in to an issue on one of my switches. I have the below configuration for each port on the switch.interface GigabitEthernet1/0/11 switchport mode trunk switchport p...
I've already installed MR1 file pi221_20150210_01.ubf, but I see a new MR that came out 25-FEB-2015 and is called pi221_20150131-27.ubf. Should I install this update as well?
Hi there. We've requested that our network provider export Netflow from the WAN facing interface on their CE router in every regional office we have, to our collector at head office. They are concerned about the fact that we would be seeing their man...
Hi, We have deployed a Cisco PI 2.2 and are able to receive emails when alerts are generated in the network, but emails are ony sent once. Is there any way to set the email frequency for alerts? In the case an alert hasn't been cleared in a certain p...
Hello, I have a customer with Cisco LMS 4.2.5 software and it needs to buy 25 new licenses. I understand I cannot longer order LMS licenses but only Prime Infrastructure. What P/N should I order?1) When I configure on CCW the P/N: R-PI12-K9 and add 2...
when I launched command "show pppoe session | i Vi46 " from cli the result is Ok , but when we try save result under tclsh #set result [exec "show pppoe session | i Vi46 "] , the result is emplty , please check if I missed some chunck of code
Recently there was a failure to ACE10 hang occurs.Service recovery is solved by the ACE module "hw-module reset".I'll use the EEM and "ip sla" for the auto recovery..However, often occurs due to a "parity error" in the reload ACE10. I want to be....I...
Dear team,we are using cisco prime 2.2 and we have one RAID disk failure and we have replaced with the new disk .After that also it is reflecting as red green led status.even the disk space also showing as same before(83..gb)suggest what is the issu...
I am trying to figure out the licensing with Cisco Prime Infrastructure...We are running 2.2 I believe that we have just the base device License, I am trying to enable NetFlow on devices in the network, but I don't see anything in PI for NetFlow and ...
Hello dear community, i try to automate export the data from the Monitor > Client and Users to .csv file.Is it possible to export the file every week automatically in .csv format to an externalserver (preferably SCP or SFTP). Or any other way.? Regar...
Hi Team,Ciscoworks LMS deamon manger failed start with below errorError:The service is not responding to the control function.More help is available by typing NET HELPMSG 2186. Below is the event i found the EventviewerThe Cisco Prime Daemon Manager ...
