Network Management

Is there a way for PI to send email alerts when a device becomes unreachable? I know there are alerts when an interface goes down, but I can't find how to get prime to alert me ONLY when a device becomes unreachable.Does anyone know how to do this? I...

Hi,I had configured Neflow on 6509 Switch having 2 vlans. 1 L2 vlan (vlan10) and 1 L3 vlan (vlan110).I am able to see netflow for both vlans but I am not able to see the mac-address for L2 vlans (vlan 10) even after configuring the command"ip flow-c...

I am new to CLI.I have a 3560 24 port switch and I need to create a VLAN 10 and include ports 12-24 at 1 GB.The 3560 shows the 24 port and the last two opening do not have a port.I was reading the guide, and the examples show using example of FastEth...

Hi everybody,I would like to know if it's possible to use a Cisco Prime Network Analysis Module for ISR G2  as a NetFlow collector.  A draft of architecture is attached. What I need to do is monitor Gi0/0 and Gi0/2 and produce reports about the total...

I have observed a billion messages like the following, on syslog :Feb 23 10:12:32 wlan-controller-14-2 impa-wireless2: *spamReceiveTask: Feb 23 10:12:29.570: %LWAPP-6-CAPWAP_SUPP_VER: spam_lrad.c:1835 Discarding Primary discovery request in LWAPP fro...

Recently upgraded to Cisco Prime Infrastructure 2.2 I cant seem to find a way to deploy a simple config to my routers (or view archived configurations) conf t Aux 0no exectransport input telnettransport output none copy run start  Am I missing someth...

Hello Guys,   Why it is showing as unsynchronized? Could you please recommend me any free NTP server? Thx. I have also tried with : 0.ch.pool.ntp.org   VOICE_1#show ntp associations   address         ref clock       st   when   poll reach  delay  ...

Hello, can someone tell me how to add a Cisco UCS Server or Physical Server in Prime Infrastructure 2.2:Inventory > Device Management > Compute Devices ? Regards, 

I need an OID to support capturing interface traffic (counter) on 2951 router. Is there a simple SNMP OID that just does that?The specific interface is actually an PPPOE interface, but not sure that matters.

Hi All,We have set a custom monitoring policy to monitor the input broadcasts on the switches' interfaces. We have set it to trigger a critical alarm if it reaches 90%.According to my understanding this means that if the broadcast traffic percentage ...

Has anyone upgraded to Prime 2.2 in a appliance form 2.0.   

I have just started migrated devices to SNMPv3 and was using the v1default view, but it appears my NMS doesn't have permission to mib1.3.6.1.2.1.17.4.3 with this view. Maybe cac_view does? I need a view that can see everything. Should I switch to cac...

Hi ThereI am using a quite old tool - Ciscoworks IPM 2.5 with CWRW-1.3 in my teaching lab installed in 2004. IPM is good tool for network lab working with Cisco 3700 routers.  Now I am trying to find latest IPM version to upgrade the lab. I find that...