Network Management

I have just installed a new Prime Infrastructure Server and have discovered our list of guest user accounts from the discovered Controllers. We are implementing ISE 1.3 and would like to move all the guest user accounts from Prime to ISE without doin...

I'm trying out Prime Infrastructure, but can't get the SSH to work with our C2948G-GE-TX switches.  The SNMP works, but when the correct SSH credentials are entered for Password and Enable, I get "Wrong CLI Credentials" when attempting to sync.  I ca...

We have enabled TACACS for all devices and configured custom TACACS login and passwords prompts. This has created a Telnet problem and huge amount of log files in our log server. Got information in RME user guide, but could not find more in CS guide....

HI, We are trying to leverage PI 2.1 to push "mtu jumbo 9000" to several hundred of our switches (2960 (G,S & X models), 3750 models, as part of a large MTU project.  We can't seem to find this function in the template library.  We are struggling wit...

 We have LMS in Our company and the planning team asks me if we need to upgrade it to LMS prime, so my question what the future or the difference between the LMS and LMS prime?

for example :Using EEM script to capture "vlan 444" under each of Gigabit interface of Switch 3750 , then change it to "vlan 888" Source :!interface TenGigabitEthernet1/1/1Holdtime : 120 sec  switchport access vlan 444!interface GigabitEthernet1/0/3 ...

Hi,can someone explain me what does it means? on my 3750x is a continuous log like thisNov 24 13:19:36: %ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error, Interface Gi1/0/26: Power Controller reports power Tstart error detectedand with this comma...

Dear Friends, Recently I installed PI 2.1 evaluation version. I bought license for that. I have LMS 4.2 installed and working fine. I have to do the following tasks. Please advise me step by step procedure of how to do it ?01. How to install or uploa...

Dear Experts, How to upload the floor map for the access points in cisco Prime 2.1 .... Thanks

Does PI or LMS 4.2.5 support N7706,N5672 and N3172 ?I couldn't find these three models on the supported device list.

Hi, is it possible the get the MAC address table on SG300 switches with SNMP?I tried with OID 1.3.6.1.2.1.17.4.3.1.1But no result Here is the SNMP configurationsnmp-server serversnmp-server community Test rw view DefaultSuper