Network Management

Hello Community,Can someone please let me know why the following script with ping size 1000 and repeat 1000 won't work, however ping 100 and size 100 will work. event manager applet test11 event none action 010 cli command "enable" action 020 cli com...

I am trying to generate a trap based on sla breach on a IOS XE router.  What MIB could I use?Here is the config from the router: track 1 ip sla 1 reachabilityip sla 1icmp-echo 50.232.60.177 source-interface GigabitEthernet0/0/3ip sla schedule 1 life ...

Hi,My switch: CISCO Catalyst 2960-S (WS-C2960S-24TS-L V03). I am trying to read some diagnostics data from the switch by using Kepserver Ex (SNMP protocol). I have downloaded the MIB files from CISCO site, RFC1213 and IF-MIB.The problem is, that I ca...

Hi Team, We have deployed PI 2.2 into one of the client where they want Cisco PI in French Language, so all coming alarm, events, setting, etc will be display in French.It's would be much appreciate if someone from PI expert will guide us how we can ...

Hi I am trying to perform ISSU on a Cisco 4k switch , 1) I have set the value of the conf-reg to 2922.2) I have loaded both of the switch with the same image.3) I have also used the boot system bootflash command with both of the images name,setting t...

I am busy with an iWAN design and part of the solution is to have Cisco Prime deployed as a management tool.The customer does not have VM and do not want an appliance.The design caters for the new ISR4400 series routers.We can add a UCS-E single wide...

Hello, someone know what is OID for Cisco TelePresence SX20 and Cisco TelePresence ISDN link (snmp trap to monitor status device/status interfaces)?? 

 Dear Team, Can we monitor DMVPN Tunnels with in Prime Infrastructure. ? If yes then how ?   Thanks a lot in advance.

We installed a CISCO 6509e with 2 Sup 720 blades in one building that is about 600m from our corporate HQs.  We have a CISC 4507 with 2 Sup 6-E with 10G.  We have them connected with fiber using 10g gbic LMR optics in the 10g ports of the sup blades....

I have a problem with WS-SVC-NAM-1 Module. Can anyone advice how to recover after unsuccessful upgrade?I successfully upgraded Application Image from 3.4 to 4.2 step by step:3.4 --> 4.04.0 --> 4.14.1 --> 4.2Next step was upgrading from 4.2 to 5.0 ver...

Hi all, I'm trying to add Ciso ISE 1.2 (1.2.0.899 with version 13 patch) servers (primary and secondary) as "External Management Servers" in Cisco PI 2.1 (2.1.0.0.87) but there appears such message indicating that ISE server is not reachable:  The we...

Hi,I have a Cisco SG200 switch. Few ports on this switch hosts inputs for video streaming purpose and few ports for general outbound internet.I need to install a secondary SG 200 switch which will act as back-up in case the current switch fails/ goes...

On all devices the cdp neighbors are successful discovered and shown in the neighbors view. But switching to topology view (global or for a single device), I see only a view connections instead of the whole topology. Is this a known bug? Any possibil...

Hello Team,  I did like to know how i can create a baseline template using Cisco prime infrastructure 2.2 in order to compare configuration of devices. Also I would like to inquire how I can generate a CLI template and view the CLI template before ap...