Network Management

Does any one have QoS experience on Catalyst 1000?  I am setting up a 8 ports model.   It looks like that I have very limited capability on QoS classification due to "Per ASIC, 8 TCP port comparators and 8 UDP port comparators are supported".   If i ...

Hello. If I check my static external IP address on https://www.yougetsignal.com/tools/open-ports/It says that port 22 is open on it. ISP is plugged to my Cisco 2901. How do I make sure the port 22 (SSH) is not open to public? I tried following sugges...

Hello, all.  Running into an issue on a handful of routers (running IOS XE 16.09.08).Startup config has the following:snmp-server group PSB_V3Group v3 priv read PSBV3Read access 6snmp-server view PSBV3Read iso includedsnmp-server view PSBV3Read inter...

Hello all. Can anyone help me with some infos of the licenses pricing for wifi access points? So I need to start a new wifi solution for my enterprise, and they want cisco. I found the cisco catalyst 9800-L controller, and the cisco catalyst 9120AXI ...

I made an event manager applet to clear a packet capture and I have a KRON job to run it at 4am but the applet doesn't work because when you run run the command "monitor capture CAP clear" it asks you to confirm at the end. I tried both of these: eve...

Hello friends,The BID value consists of 32768 + VLAN ID/MAC address, but here the default VLAN ID is 1, but according to what is the VLAN ID value when different vlans are entered to the switches? Or is it given to Native Vlan? I will be very happy i...

Greetings,I am using a Cisco ISR4321 running IOSXE 16.06.04 I am trying to get started with NETCONF and according to every tutorial I've read the command "netconf-yang" should be enough to start the NETCONF service and open Port 830, however, trying ...

Hello.I try to Putty SSH into a geographically distant 2960x , IOS 15.2(6r)E, it times out.I tracert via Windows CLI, success.I ping via Windows CLI, success.Pinging 172.16. with 32 bytes of data:Reply from 172.16. bytes=32 time=26ms TTL=253Reply fro...

Hello, we made a change to a SG350-10P switch to disable smartports on a single port. This change was made in the Smartports > Interface Settings > Interface Settings Table. This change has had the undesired effect of throwing a load of network devic...

My office has about 14 branches including the head office with server. How do I network these branches to have connection with the head office?