Network Management

we have purchase cisco prime for a customer, we have got software paper license from distry.  3 license is there with defferent PAK 1. R-PI12-BASE-K92. L-PILMS42-503. L-PI12-LF-50-LICi have register first one and got the license file as per instructi...

Hello,   I am a systems engineer and I am looking for some help with my current network setup. I am in need of a program that I can give the IP addresses of my cisco components (PBR's, Switches, so on) and it will go into them, pull the running confi...

Hello,I've found something confusing. Please have a look below. Has anyone the same feature or is familiar with that?We replaced a 4400-series WLAN controller with a 5500 series controller, the UDI information was discovered correctly but the general...

hii am yves ndjami, i want to install a ciscoworks server lms 3.2 in a windows server 2008 standard version, i started by doing the server setup but this is the message that i received during the process:"CiscoWorks Assistant does not support th...

what is the difference of the commands "show ntp ass det" and "show ntp status" ?these commands differs on the referenced time source.switch#sh ntp ass detailLoad for five secs: 17%/4%; one minute: 20%; five minutes: 20%Time source is NTP, 10:45:15.4...

DearsI am working on a scenario to monitor a CPE in a layer-2 setup. The CPE is connected with the local PE across a last mile with a single vlan from the provider. The customer has purchased layer-2 end-to-end connection from local CPE to remote CPE...

Hi,Can we install the CPN 4.0 on a VM ? Or Do we need to install the windows server first and then install CPN 4.0 on that just like the way we install any other software on windows ?Pls. suggest and share any relevant document for the same.RegardsHa...

Hi,We're deploying a decent amount of Cisco switches and I would like to know if there is any Cisco software (paid or free) which would give me a centralised management platform, monitoring and backups for all the devices?I know I can use Spiceworks ...

Hi,I’m stuck in some problem with installation of LMS4.0 in customer site.Please give me feedback for following situation.- we purchase a LMS4.0(CWLMS-4.0-100-K9) but couldn’t install it on Windows server 2008 R2 64bit because those things don’t supp...

Hi,Recently been using Cisco Network Assistant 5.4 to back up the configuration of my Catalyst 3500XL switches.  However, yesterday for the first time I tried using the Maintenance/Configuration Archive Restore function to load the configuratin on a ...