Network Management

Why does Prime Infrastructure 2 not recognise a 1532AP? the 2504 wireless controller reognises it & clients associate to the AP.But when you try looking in Prime Infrastructure under Monitor/AP or Configure/AP they are not there.Thanks for your assis...

Hi, customer wants to poll some interface-counter more or less in realtime for some reasons, IOS does not update the Mib-vRiables in real-time. So the was a hidden command in "normal" IOS to change this behaviour , to force IOS to update the counters...

I already uploaded the third party device's MIB to PI2.0,  but could not recive the third party device's SNMP TRAP properly .what do I need check for the PI ? or what do I need to setup for the PI?  Thanks    

I have strange behavior with our CPI at the customer site. With no apparent reason we have noticed that the web interface was not accessible. After the restart all proceses were in up and running state and we were able to log in again. My guestion is...

Hi,I’m using CISCO Switches / Routers and wanted to capture the CPU Utilization of those devices in MRTG. Can anyone help me to get step by step information. Please.!

Hi,I have strange behavior with our CPI at the customer site. With no apparent reason we have noticed that the web interface was not accessible. After the restart all proceses were in up and running state and we were able to log in again. This is the...

Hello,I'm trying to figure it out how exactly LMS learns about ports in err-disable state? Which MIB or command is used?I have two ME3400 switches with err-disabled ports but LMS shows only the ports of one of the them. Both switches are ME-3400-24TS...

I have a WS-C2960C-8TC-L Switch, I would like to know if this is a Layer 2 or Layer 3 switch.I am running IOS image: c2960c405-universalky-mz.152-1.E2I am assuming its a Layer 2 Switch.  I need put an IP address on GIG0/1 but when I input the followi...

Hello , When you install a CPI 1.3 Virtual appliance on esx5.0 , vmware report the vmware-tools provided with the CPI image is too old and should be updated ..My vmware specialist would like to update the tools from ESX . Is that can be done ? Is som...

Hello,does Cisco implement some OID to get traffic engineering (te) metric of the link when using MPLS TE? I need actually to write this parameter over SNMP so i need to find an OID through which i get/set this parameter of link. I was looking for it...

Hello,I use LMS 4.2.4 on Linux (virtual appliance).I have a Cisco 4500X switch in VSS mode (SysObjectId is 1.3.6.1.4.1.9.1.1732).I looked up at the LMS supported device list for all LMS 4.X versions and I coud only find it in the document for 4.2.2.I...

Hello Community, I wonder if someone could please help me discover why we can't get our primary Cisco Secure ACS, UK-SU-AP091, to replicate with our secondary Cisco Secure ACS, UK-SU-AP092?They can both talk to each other, but the replication status ...

Dears;can any one help ?  our PI 2.0 is very very slow in response, i click and go do other job until it loads, some time it works fine for a few minutes and then back poor again. this result i can't manage any thing.ThanksRegards