Network Management

Hi, I am having issues with configuring performance monitor (medianet) on an ASR1002-X.The command '(config)#policy-map type performance-monitor' does not exist despite documentation stating otherwise.All the other required commands work fine. Just t...

Hello all, I would like to use archive with SCP protocol on VSS (two Catalyst 4500-x with 15.2.2E ios). The configuration is the following on the VSS:archive path scp://backup:backup@10.1.1.1/$h-cfg-backup-$t write-memoryI use the same configuration ...

Hi All,How can I get historical utilization graphs of router interfaces in pdf or other format in PICiaoJC

Hi Folks,I want to integrate CiscoWorks LMS 3.2 in our 3rd party Tacacs+ Server (Alcatel Lucent 8950 AAA).I found only some manuals for integration of CW LMS into Cisco Secure ACS.For testing purposes I started a wireshark session, while I clicked on...

Hi freinds,by default, ciscoworks save's file's named "asat000X.TMP" in c:\windows\temp.any tmp files saven to this folder by windows settings.i can change the destenetion folder for all "tmp" files by change the setting's in the operation system, bu...

Hello everybody. Just a little question: We are using Cisco Prime 2.0 If I install a LMS 4.2, am I able to use the lms-licenses of the existing Prime 2.0 to activate the LMS? The reason is, that I'm missing a lot of features of LMS in Prime 2.0  Thx ...

Has anyone encountered the error above? I keep getting the alerts and I see that one of my ntp status shows INIT. I tried removing that ntp (insane) from the router and alarms disappeared. I somehow can not establish ntp sync with it but my other rou...

I'm running LMS 4.0.1 on a Win2008r2 platform.  I can hit the main log in page, but entering a username and password results in the following message being displayed:ForbiddenYou don't have permission to access /cw;ms/gsHome.do on this server.Additio...

I have the C2960X-48TS-L with IOS 15.2(2)E and I try to run udp_open through tclsh (either from flash or directly) with no luck. I always receive the message invalid command name "udp_open".Am I doing something wrong?I try to include the WOL function...

I'm very new to EEM and have created an applet that will send a email when port secuirty has been tripped and is logged in the syslog. I'm trying to figure out how to have the applet only send one email and not continuesly send as the messages log. A...

Does anyone know how to create an EEM script to kick out a syslog upon a serial interface signal loss? To view the signal loss you have to look at the T1 controller interface and I don't see an option in EEM to monitor the controller or the T1 interf...

Hello guys! I have a problem regarding the NCS 2.1.1. I have the NCS 2.1.1 connected with the ISE 1.2.1 patch 1. and have a handful of switches configured into the ncs. If a client connects, with 802.1x port security the ncs takes AGES to register th...