Network Management

I am trying to find a way to monitor bandwidth usage by protocol on each of my client machines.  This will give me info on any offending applications/services causing high bandwidth utilization.  It sounds like the 2960s I have do not support netflow...

Hi all,When I check the output for the command "show environment temperature all" I see high temperatures reading, is this ok ?? router#show environment temperature all   module 1 outlet temperature: 53C  module 1 inlet temperature: 34C  module 2 out...

Dear Cisco Guru's,We are currently testing Prime infrastructure 2.1. Is it possible to export CSV reports to an external repository ??Apparently, Repository path points only to localdisk/ftpWhat is told in the 2.1 pi admin book :Off load backups and ...

Hi,does anybody know by chance under which folder or in which file Prime writes executed CLI Template Jobs to troubleshoot failed jobs?Thanks

Been getting alot of these syslog messages. I think perhaps a system job is failing but I don't know where to start to troubleshoot. 09 03 2014 11:23:13 [pi-ip-address] <LOC7:ERRR> 09/03/14 11:23:13.484 ERROR [jobmanager] [seqtaskexecutor-12371] ERRO...

I currently have 150+ switches and routers in Prime Infrastructure 2.1. I was looking to see if there was an easy way to run a report on the switches and routers to see if any were not running SSH or TACACS+. Thanks

I am attempting to upgrade the IOS on all of my Cisco 3560 switches at remote sites.  I am having issues performing this transfer remotely.  So I am using a management server located at our datacenter as the TFTP source.  I have installed both TFTPD3...

Request you all to please let me know if i have to install point patch before upgrading the cisco prime infrastructure 2.0 to 2.1.

Hello,I have a customer running CPI 1.2 and was running into bug CSCuf13631.In bug search tool, I see that this bug is in "Fixed" status, but release-pending.Do you know what is the ETA and version number of PI on which this bug will be fixed?Thanks.

  I deploy ovf file for lms 4.2 in vmware, but after turn on the virtual machine i faced with attached error, please assist. 

Hi ,How to enable snmp in cisco devices.Any one know that you default community string for Solrawinds ? 

Hello,I'm new to this system Cisco Prime Infrastructure and faced some issues while doing configuration.In Operate>Clients and Users I can see all the users connected to it. I want to remove or disable the client connected to the particular switch bu...