Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

Buen dia Tengo actualmente mi plataforma de Cisco Prime LMS configurada y funcionando, pero me genera una duda por que la plataforma solo registra la IP del dispositivo y no el Hostname de este.

Resolved! PI2.0 config scan

I'd like to scan the devices/configurations in Prime for particluar entries, snmp, tacas etc.  Similar to what there was in Cworks is there a method within Prime for scanning for particular arguments ?

SpongeRob by Level 1
  • 695 Views
  • 4 replies
  • 0 Helpful votes

Hello Support,I have created the following script to send me an email when the cpu is high on our router:event manager applet high_cpuevent snmp oid 1.3.6.1.4.1.9.9.109.1.1.1.1.3.1 get-type exact entry-op gt entry-val "5" poll-interval 60 action 1.01...

Hi,hi Team,we have VPN configured in PRTG however we are facing the problem is that whenever there is no traffic on vpn tunnel prtg shows that this vpn is down more ever at this time vpn is up not becuase of no traffic on tunnel its does not particip...

We recently installed a Prime 2.0 appliance, currently v2.0.0.0.294.  When I import a drawing the text "Demonstration purposes only" gets added across the top left, outside of the actual drawing space but it becomes part of the building floor view.  ...

ericlenz by Level 1
  • 453 Views
  • 1 replies
  • 0 Helpful votes

Hi everyone!We're facing high cpu utilization for a Cisco Catalyst 3750X (5 switches in stack), running IOS v 15.0.(2)SE5.  The cpu reaches 80-90 %We don't know how to troubleshoot this issue, and i'm not sure if this could be related to many packets...

Soporteco by Level 1
  • 899 Views
  • 1 replies
  • 0 Helpful votes

All,I'm working with LLDP for the first time and currently unable to get a 7945 ip phone to register with a Cisco 3560-E series switch.  So far, I've enabled LLDP globally on the switch, turned on transmit/receive, and initialized "lldp med-tlv-selec...

hi All, I am getting an error as below on a 3750V2 connecting to a 6509 WS-X6724-SFP port. I am getting Input errors on interface at 3750v2 side.3750V2# sh loggApr 14 09:42:57: %SFF8472-5-THRESHOLD_VIOLATION: Gi1/0/1: Rx power low warning; Operating ...

Review Cisco Networking for a $25 gift card