Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

 
Labels

Forum Posts

Hi,I noticed in Cisco Prime 4.2 when we try to look for devices that are unreachable, we went to Reports>Inventory>Management Status>Unreachable Devices, but the devices indicated there are currently Up. We have another Cisco Prime Demo server not co...

Hopefully im in the right section and that you can help!I download ccp to configure my router, however whenever i run it (as administrator) it only fills the top 1/3rd of my screen and cuts off a huge portion of the display (in fact you are initially...

                   We are running Prime Infrastructure 1.3 primarily for wireless management at this point.  We have enough licenses to add all our switches, routers, and firewalls, but we're hesitant to do so until 2.0 comes out.  While there are so...

I have Cisco Prime LMS 4.2 deployed.  How can I use it to determine which of my routers and switches are not configured to support ssh?   Clearly I could log into each device and do it by trial and error but I'd like something a little more elegent. ...

Tod Larson by Participant
  • 768 Views
  • 3 replies
  • 0 Helpful votes

Hi All,I was wondering if its safe running a script on a endless loop?Reason is, I want to monitor my network outages and other network problems in real time, and also get notified right away. But im not sure how the router will handle this loop scri...

uranthaci by Beginner
  • 4265 Views
  • 5 replies
  • 0 Helpful votes

Hello Community,Can someone please take a look at the script below and tell me why on earth the simple script won't work when I try to run it manually,event manager applet netflow_toptalkevent noneaction 1.0 cli command "enable"action 2.0 cli command...

Hello - I am trying to find some detailed information on IP SLA probes. We are implementing udp jitter probes in our network, but I am curious about what constitutes a test failure. Considering the default test parameters (10 packets, 10 bytes, space...

Dear Friends,            I am in process of configuring hsrp using dynamips       when i am putting the comand    SW1(config)#standby 1 ip 10.1.1.10                                           ^                                   % Invalid input detecte...