Network Management

Cisco PI 1.3 How do you find device by MAC or IP address? I want find out on which device the end host is connected by entering MAC or IP address.I was able find the end host with LMS 3.2 Campus Manager->User Tracking->Report. My end device is Cisco ...

Hi,I am using the divide function and I've found that if the remainder starts with a zero the leading zero is dropped. In my script I want to check if the output of $remainder is 6 characters and if not to add a leading zero, any idea of the best way...

Hello Community,I have situation where a script called netc.tcl is active but doesn't actually exists i.e. not registered.MX-IPS1#show even manager policy active Key: p - Priority        :L - Low, H - High, N - Normal, Z - Last     s - Scheduling nod...

[Clarke! HA! I just loved it when they used to call you that! Hey Rockstar, long time no see. If you do see this =-) Your biggest fan is back on the boards asking really dumb questions...]I am working my newly inherited LMS3.2 into shape so I can mov...

I have the following script running to report on routing table changesevent manager applet route-table-monitor event routing network 0.0.0.0/0 ge 1 action 0.5 set msg "Route changed: Type: $_routing_type, Network: $_routing_network, Mask/Prefix: $_ro...

Hi guys, I just found an error on using the script and the action doesn't work. It says there's something wrong with the variable "hour". How can I resolve this? Thanks.Script:ROUTER(config)#event manager applet cell2ROUTER(config-applet)# event sysl...

HiI am trying to configure template for collecting traffic statistics through PI.As per the steps in the Cisco PI document, I tried configuring the new Template, but I am not able to edit the "Form View", not able to fill any row in the "Form View" s...

I am new to the scripting world and do need assistance in developing a script that will assist me to perform the following tasks when executed1] remove all existing tunnels2] remove dialer/BVI interface3] create new DMVPN tunnel- tunnel x--- MPLS con...

                   Hello I need help, my Cisco Router (2921) work not correct with tcl script. Tcl script work fine on this device long time, but in one time script was not start get error(no any script changes):005495: Aug 26 08:46:27: %HA_EM-6-LOG:...

I am trying the Cisco Prime Infrastructure, trial version.In client management I can see only 802.3 clients, but not clients directly attached to the switch ports.Finding where a client, searched by IP or MAC address, is connected, is a mandatory nee...