Network Management

I have one firewallASA5520, are very slow

Hello, I'm unable to add access points to a floor area in CPI 1.3.0.20I tried with IE, Chrome, Firefox, but the message was always the same: Error:COMMON-1: Some unexpected internal error has occurred. Ifthe problem persists please report to the Tech...

Hi,I tried to access one of the devices in Topology Services in Cisco Prime thru SSH but was unsuccessful. How can I make it work? Do I need to install "putty" on the server just to make it work?Thanks in advance.

Have old LMS 4.x server, now built a new Prime 1.3 and transfered base license and 1500 lifecycle to prime server on a VMI am trying to now build the prime server from scratch.  It seems that only the wireless portion is supported.  Does prime 1.3 no...

HiWe have started using Cisco Prime for our network management. On our sites we have a few devices managed by other vendors which are non cisco devices, we would like to keep these in the diagrams on cisco prime but since we don't manage them we don'...

Good day.It seems that Prime LMS builds a topology only by cdp, is it possible to use lldp for this purpose?Or any other method to see in topology none cisco devices?

Hi my name Ismail,Can the EEM output for example "show proc cpu his" save on external syslog server rather than flash memory. Im running Nexus 7010

Hi,I'm seeing regular virtual-access interface flaps. Is there a good way to keep a count of these? I could monitor the syslog and increment a counter however there must be a more elegant way to do this. I can't find an OID or show commands which giv...

I'm using Cacti to monitor our Nexus 5548UP devices.  I can monitor the physical ports, and the Port Channels, but my layer 3 interfaces (vlans) I can not.  Is this a limitation of the 5548 since it needs the daughter cards in order to do layer 3?TIA...

Hi Team,My goal is to achive that if the CPU utilization is greater than the 50% run the "undubug all" commandTo avoid the high tilization due to debug (I know that the access - list should be used for the same , but i want to achive this)Below is my...