Network Management

Hi Guys,I hope someone can aid me here.why does my eem email give me the wrong time with the use of "$_event_pub_timeI got an hour out on my email but the clock on the switch is correct.Switch says 17:07:16.831 GMT Mon Sep 9 2013email comes back with...

the windows server has the right time and time zonecisco prime is 1 hour backhow do i get prime to use the windows system time or let me manually set it in prime settings?(same with wcs server)thanks

Hello everyone, I have a few voice gateways with some E1 links which have 15 outgoing and 15 incoming channels at each link. Using a SNMP monitoring tool I am able to get the number of active calls by querying the OID 1.3.6.1.4.1.9.10.19.1.1.9.1.3 ca...

I want to create some basic alarms on our infrastructure. I want to monitor only specific ports on specific switches. I do not want to monitor client ports, only uplinks to distribution/core and server ports. Is it possible to get alerts only from sp...

Hi,I have two questions to PIs device temperature monitoring. 1) We have some stacked switches and some switches in a VSS. Also we have some switches with multiple temperature sensors. For example here the output of a C4506-E with a SUP7.#show env te...

  This is a bit different than the other Nexus NTP issues that came up when searching the Community forums. Here is the scenario:I'm in the Eastern timezone (EST). Time is correct on the Windows DC that we are using as a time server. Config on the Ne...

I'm at my wits end here.  We just recently purchased a 3945 ISR G2 router and have a SRE-910 module (with two hard drives) configured in a Raid 1.  We are running a stand-alone version of ESXi on the service module and I'm trying to figure out how to...

Hello thereI am having a strange issue deploying universalk9-150-2.SE2 to our 2960S. All the switches are stand alones.LMS gives an error when asking to upgrade the image but the fact is that the new software wents through - if I manually reload the ...

Hello Everyone,"CM051 Vlan Running Config Fetch Failed For x.x.x.x Cause:Command FailedTelnet:Failed to establish telnet connection to x.x.x.x-cause connection refused.Vlan config job not supported using TFTPVlan config job not supported using SCP"I ...

Hi,I noticed that when one of the devices being monitored in Cisco Prime 4.2 went down, it did not appear as "red" immediately on the Topology Services map. It appeared s red maybe after 30 mins or so. Can you help me adjust this?Thanks in advance.