Network Management

Bonjour j'ai installé ciscoworks LMS 2.6 sur mon serveur et en accedant au Device Credentials and admin j'ai ce problemeDCA Server is down or inaccessible aussi j'ai  JRM server is down or inaccessible for this  userI have installed a ciscoworks LMS ...

Hi All,I 'm facing a issue with the discovery module, when i create a job for discovery either immediate or scheduled. The job triggers and status would be running.But i'm not able to see the  progress of the discovery status(it displayed ""No recent...

Good day,I have an issue with our CiscoWorks. After I applied several patches to the CiscoWorks, the apache services wouldn't start. Every time I try to start "CiscoWorks Web Server" service, it gives me "Windows could not start the CiscoWorks Web Se...

Hi,i have a new cisco prime network control system appliance (NCS) I completed the initial installation however post installation it performed a reboot and is now stuck at Init Level 3.I have restarted the machine several time but the same result.

Hi Netpro I ve recognized some strange issue with LMS 4.2 , when the router becomes down or unreachable , the LMS doesn't send any event as Faultview,also when the router comes back online the LMS takes 1 hour to show its state as  reachable , how ca...

Hi,We migrated to LMS4.2 and i created new credential set and set it as the default. However, the new cdredential set applies only to newly added devices no to the migrated devices. for example when i run device credential  verfication for a migrated...

Currently when a device, say a router goes offline we receive two Active 'Unresponsive' alarms for the router and then when it comes back online we receive two Cleared 'Unresponsive' alarms. All have their own unique Event ID. (shown below)I was wond...

Buenas tardes Sres.Tengo un router ISR Cisco 1941/k9 configurado y en operación, tiene levantado el feature NAT, IPS, Zone based IOS Firewall. Dispone del IOS 15.2(2)T2 y licencia ipbase y security.Necesito monitorear el equipo con mi OpManager a tra...

Hello Cisco CommunityA program that I'm using to manage cisco devices has created a .cfg file in nvram in a gns3 router. When the program tries to access the I get the following error message:'Could not open policy cfg file'The file is a Tcl file. Th...

Hi all,We are replacing our Cisco 1801's with 887VA's.  So far we have done 22, but all show in Cisco Works as "Unknown Device Types".  How do I make them "known" & known as 887s? Thanks

Hi Guysi have configured one of my device for testing purpose to send SNMP traps <ex,Link up/down to my LMS 4.2 , i have adminstravily shuted down the uplink interface of the switch , however from the LMS side , I didn't see any thing , pls help me t...

Hello All,Can someone please explain the following error when I try to run a script and how to fix it?unknown namespace in import pattern "::cisco::eem::*"I have attached the scriptCheersCarlton

I have a ASA5510 ASA v7.0.8 in routed firewall mode. It is setup as the internal router and default gateway. I was asked to set up a wireless router, I chose a D-Link DIR-815 (we are a small buisiness). I have it all set up but I cannot get any name ...