I am looking at rebuilding a C9407 switch in the near future. I would like to start with factory default config. The issue is that I can't reset the one have as it in production. I looked around but I can't find anything. Does anyone have a copy or k...
Forum Posts
Good Evening,Note: I don't belong to an organization who sells Cisco equipment, so my knowledge is limited the documentation made available from Cisco. If this needs to be escalated directly to Cisco support (TAC), I can have our client submit this d...
Hello.I'm trying to understand "%SPANTREE-5-TOPOTRAP: Topology Change Trap for vlan X" log line. Could someone explain this to me, I'm a beginner in networking and switch configuration in general.I'm suspecting this topology change notification be ...
Hi I am learning to secure administrative access to a router in packet tracer and would be grateful if anyone could feedback on my configuration. Many Thanks ip domain name cisco.comservice password-encryptionsecurity passwords min-length 10username...
Hello all, i've configured my new cisco switch 9200i've put the fibre port in trunk mode, allow all vlans, etc.in the 3750x i can ping it and from all 2960s/x i can ping it to however when i try to ssh or use the webgui it says "connection time out" ...
Hi everyone,For example, Interface f0/16 connect IT-Support department and switches , and is used for management Vlan 204Why when I apply 1 sticky mac address (Protect violation mode) for all interfaces from f0/1-16 , computer from management Vlan ...
Hello I had a Cisco 927 Router and want to integrate it in our ACS. Where do i find a Data Model in XML format for TR069?? Best regards
I receive the below message on my Cisco SG350 Switch%MNGINF-W-ACL: Management ACE drop packet received on interface VLAN 1 from 10.50.0.4 to 10.10.20.85 protocol 17 service SNMPfor more, I have attached the screenshot of CLI.
Hi,I'm troubleshooting a LACP port-channel which randomly gets unbundled. At this point, I don't know if it is due to a hardware error (switch of SFP) or bad fiber. When I do a "show etherchannel detail", I can view the time since it was last unbundl...
Hello fellows, I have a little issue with VLANS. I have FGT 80F and 9200Example configuration:on FGT: - ports 1-6 are in switch with IP on internal, VLAN 10 and VLAN 20.internal IP: 172.16.100.1/24VLAN 10 IP: 192.168.16.0/22VLAN 10 is allowed to acc...
Hi all,I need to replace a certificate on an IOS-XE router.A third party has requested that I provide them a CSR from the router.How do I go about this?The router is version 16.06.02.
Hello all,I have ASR1004 and a freeradius server. I try to assign static ip address to subscriber. I tryed "Framed-IP-Address" and Cisco-avpair "ip:addr=x.x.x.x", but seems Cisco is ignoring them. I also tryed configuring seppared ip pools for each s...
Resolved! how to check warranty of cisco switch
Dear Team we try all process but not able to find the way to check my cisco 4500 switch warranty on cisco portal pl. help as and share as link for the same
hi everyone, does anyone know if it is possible to restrict WAN access but still enable LAN access based on MAC address for this model?"c881g" thanks in advance
Not sure if this is possible or not in Cisco Packet Tracer - can I set up users with different access permissions, e.g. different access rights to READ ONLY or READ/WRITE on a server (accessing/logging in from a workstation to that server)?
