Network Management

I have two applets I am using to track connectivity and add or remove an ICMP ACL to an interface based on the tracking state. On the "up" applet I have two correlated events, one for tracking and the other for a cron timer. Essentially I want to add...

Hi,we use EEM 3.2 to send email whenever interface goes down/up. But it doesnt work.We need to use authenticated SMTP server, so command for sending mail is followingaction 1.0 mail server "cisco:password@domain.net" to "someone@somewhere.net" from "...

Hello All,I am getting error in authetication when I am trying to access a switch through tacacs. I have added the switch in ACS server.The aaa config is aaa new-modelaaa authentication login default group tacacs+ lineaaa authentication login console...

Hello,I encountered many problems since I have received my new Prime NCS appliance. Infact, it take 3 or 4 hours to boot and get the prompt (and sometimes, it never appears). I have downloaded the ISO file to reinstall the appliance, and I have teste...

Hi,I have an MPLS router which is fully utilizing all the bandwidth , is there a command in Cisco Routers to see which ip from LAN segment is generating what traffic ??Thanks.

Running fault device discovery after adding approx 50 new devices to LMS DCR. It seems I have reached a limit in DFM with regards to how many device components it can manage. The devices are put into questioned mode and the following error is seen in...

On a Cisco887VAG+7-K9 router, I want to be able to use IP SLA and EEM to track connectivity to an external address via my ADSL line, if connectivity is UP then I want the 3G interface to be admin shutdown.  If connectivity is down, then I want the 3G...

Hello people !I would like to be able to create a template that checks a device hostname and  takes actions according to it - my goal is to enable Energy Wise Domains - one for every location.If I could have LMS4.2 to check the hostname of the device...

I have a client using PRTG program to monitor Routers and ASA5520 Firewall, for Router are fine but ASA5520 only shown interface status, but not able to show VPN tunnel information whether the tunnel is up or down.One of the Engineer there memtioned ...

Hi allWe use Prime Infrastructure 1.2.1.012. Yesterday I installed a certificate signed by our internal CA. I installed it and the access worked fine.Now today I can't anymore access it. Neither Chrome, Firefox nor IE10 can load the site after the lo...