10-06-2009 12:33 AM
Hi, has anyone used BQM v3 in anger?
I'm tring to install one using switch Span ports / without passive taps.
The device seems to work but only "sees" local traffic and not remote site traffic(remote sites are over MPLS N/W and are all configured within BQM).
If I configure the local sites subnets within BQM then it shows no traffic at all!
I guess what I'm really looking for is a fundamental guide to how this device should work.
any thoughts?
many thanks
John
10-12-2009 08:51 AM
10-13-2009 06:56 AM
Thanks for your response, unfortuantly I have already read that doc.
I still haven't met anyone who's used BQM - I'm guessing that this is one of those products that few people bought!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: