Can't Ciscoworks LMS 4.2.2 back up the configuration of Cisco VPN 3000 concerntrator?

[robert.huang]

Hi All,

In VPN 3000 concerntrator, I've enabled tftp, telnet, snmp. I've also successfully added the concerntrator into Ciscoworks LMS 4.2.2. All the ports are verified open to Ciscoworks. No question mark shows next to this device in the device management of LMS. However, when I run configuration Achive Job, I always get the following failed message. Can anybody tell me how to to back up the configuration of Cisco VPN 3000 concerntrator in Ciscoworks LMS 4.2.2? Thanks in advance.

[Marvin Rhoads · Accepted solution]

Sorry, but apparently not. Please see the supported devices table (here).

That table states, among other things:

The following features are not supported:
Network Topology Layer 2 Services
Fault Management
Configuration Deploy Protocols: HTTPS, TELNET, SSH, SCP, TFTP, RCP
Configuration Fetch Protocols: HTTPS, TELNET, SSH, SCP, TFTP, RCP