hi,
I can't connect to my newly purchased router 2900 using serial cable and it has no display on the terminal? before console i working fine but today its'not working.
Note: telnet is working.
I Tried the Following.
Change new workstation for testing, Console cable, terminal, use usb-serial & change baud rate but the result is same it's blank.
also verify line console 0 run all configuration.
line con 0
motd-banner
exec-banner
exec-timeout 10 0
timeout login response 30
privilege level 1
password 7 0706354F
flush-at-activation
logout-warning 20
absolute-timeout 0
login
modem answer-timeout 15
modem dtr-delay 5
data-character-bits 8
exec-character-bits 7
special-character-bits 7
domain-lookup
exec
length 24
width 80
history size 20
history
editing
monitor
escape-character soft DEFAULT
escape-character DEFAULT
autohangup session-timeout
ip netmask-format bit-count
ip tcp input-coalesce-threshold 20
databits 8
stopbits 2
start-character 17
stop-character 19
speed 9600
please see the attached photo.
any suggestion?
thanks