cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
718
Views
0
Helpful
1
Replies

Can't view Mac address-table on switches in Cisco Network Assistent

FabianGR
Beginner
Beginner

Hi,

 

In our company we have a network with 6 normal switches with software version: "------ --UNIVERSALK9" and one Coreswitch with software version: "12.2(55)SE10-IP-BASE-CRYPTO"

 

When I try to view the mac-address table from the core-swtich in CNA I see all of the connected mac-addresses. But when I try to see the mac-address table of any other switch I get this error below. Our login credentials are level 15 and I tried to reinstall them on level 15 but this didn't worked out.

 

Has anyone a solution?

cant view mac [RMW].png

1 Reply 1

marce1000
VIP Mentor VIP Mentor
VIP Mentor

 

 - Probably the designated switch version is incompatible with the current CNA version ; don't put too much hopes on CNA however, it has many bugs and support from CISCO is dwindling.

M.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers