cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
865
Views
0
Helpful
1
Replies

Can't view Mac address-table on switches in Cisco Network Assistent

FabianGR
Level 1
Level 1

Hi,

 

In our company we have a network with 6 normal switches with software version: "------ --UNIVERSALK9" and one Coreswitch with software version: "12.2(55)SE10-IP-BASE-CRYPTO"

 

When I try to view the mac-address table from the core-swtich in CNA I see all of the connected mac-addresses. But when I try to see the mac-address table of any other switch I get this error below. Our login credentials are level 15 and I tried to reinstall them on level 15 but this didn't worked out.

 

Has anyone a solution?

cant view mac [RMW].png

1 Reply 1

marce1000
VIP
VIP

 

 - Probably the designated switch version is incompatible with the current CNA version ; don't put too much hopes on CNA however, it has many bugs and support from CISCO is dwindling.

M.



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco