Cancelled: Cisco Active Advisor Upgrade for Tuesday, Nov 28th @ 6:00 am US Central
This upgrade has been postponed a few days. I will update this thread once a new window is scheduled.
Cisco Active Advisorwill be upgraded on Tuesday, Nov 28th at 6:00 am US Central Time. During this time the site will be unavailable for about an hour. We apologize for any inconvenience this may cause.
Among the updates are:
- Organize devices by "Networks". This update allows you to name, scan, and group devices as needed. Existing devices can be found in the "Uncategorized" network - Improved Serial Number discovery support for some ASR9000 devices
- Discovery support for Time Sensitive Networking Routers, Catalyst 9300, and Catalyst 9500 Switches
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...