Catalyst 6500 console access

[aleksandrpartnenko1]

Hi Guys,

I've got a console connection to Catalyst 6500 with 2 supervisors via terminal server, what would be the right way to determine to which of supervisors console I connected to?

Swich software:

s3223_rp Software (s3223_rp-ADVIPSERVICESK9_WAN-M), Version 12.2(18)SXF13, RELEASE SOFTWARE (fc1)

Supervisor model:

Policy Feature Card 3       WS-F6K-PFC3B with MSFC 2A daughterboard WS-F6K-MSFC2A

[AFROJ AHMAD]

Hi ,

use the below command to the active n standby Sup::

**show module

**show redundancy

Thanks-

Afroz

**Ratings Encourages Contributors ***

[aleksandrpartnenko1]

These commands does provides information regarding supervisor status, but what I would like to know, if it is possible to know to which supervisor console port you are connected at the moment.

Show line does not state it

#show line

Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
* 0 CTY - - - - - 0 4 1/2439 -