cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
593
Views
0
Helpful
1
Replies
Highlighted

CCP Express wont install on 2821 router

Hello everyone,

I am trying to install Cisco Configuration Professional 2.4 Express on my 2821 router. During the installation process, I get notified there is 0 bytes available of routers flash memory. When I run a "show flash:" command, I receive the following error:

%Error show flash: (No device available)

The output of the "show version" (edited) command is:

Cisco IOS Software, 2800 Software (C2800NM-ADVENTERPRISEK9-M), Version 12.4, RELEASE SOFTWARE (fc1)


ROM: System Bootstrap, Version 12.4(1r) [hqluong 1r], RELEASE SOFTWARE (fc1


Router uptime is 2 weeks, 5 days, 4 hours, 54 minutes

System returned to ROM by power-on

System image file is "flash:c2800nm-adventerprisek9-mz.124-12c.bin"


Cisco 2821 (revision 53.51) with 512000K/12288K bytes of memory.

Processor board ID FTX1006C4SB

2 Gigabit Ethernet interfaces

1 Serial interface

2 Virtual Private Network (VPN) Modules

DRAM configuration is 64 bits wide with parity enabled.

239K bytes of non-volatile configuration memory.

500976K bytes of ATA CompactFlash (Read/Write)


Configuration register is 0x2102

After some reading on Cisco site, I saw that 2800 routers do not support internal flash, but only CF cards. What I would like to know is how can I install CCP Express on CF card?

Thank you in advance.

Everyone's tags (5)
1 REPLY 1

Re: CCP Express wont install on 2821 router

bump?

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards