cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
174
Views
0
Helpful
0
Replies

Change aging-time for a bridge-domain on Cisco NCS520

kosotiro
Community Member

Hi,

On a Cisco NCS 520 I see that there is the following command bridge-domain <domain-id> aging-time <10-1000000>
where we can set the aging time for the learned FDB entries inside FDB table for a specific bridge-domain.

My question is what happens with the already FDB entries learned for this domain that are governed by the previous aging-time setting till the moment we apply the change to the new configuration value of aging-time. Will the time that has been passed due to aging from previous value setting be counted on or will aging restart again for this FDB entries with the new value without considering the past?

Is anybody aware of it?

Thank you,

Costas

 

0 Replies 0

Review Cisco Networking for a $25 gift card