11-23-2023 02:43 PM
Hello everyone. I'm working on a Firepower 1010 v7.0.1-84 in a test environment. To access the firewall dashboard, I need to enter the IP address 192.168.95.1.
How can I change the inside IP address? I've been searching for several weeks and haven't found anything in the documentation.
Thanks in advance for your help.
11-23-2023 02:53 PM
Use FDM to access frp and check inside IP.
11-23-2023 02:59 PM
11-23-2023 03:14 PM
Device->interface
Show me what appear
11-23-2023 03:23 PM
11-23-2023 03:38 PM - edited 11-23-2023 03:53 PM
Check below
MHM
11-23-2023 03:42 PM
for which interface? You should know that interface 1 must keep the IP address indicated because it is fixed. What I want is to change from 192.168.95.1 to 192.168.1.1
11-23-2023 03:51 PM
Sorry you want to change IP of interface you access through it to ftd?
If yes then check this guide
11-24-2023 12:41 AM
Thanks, I'll look into that. Is it possible to change vlan 1 to vlan 99.
12-07-2023 07:41 AM
VLAN 1 is always there and can not be changed or deleted but can be disabled. You can add additional vlans though.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide