cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1212
Views
0
Helpful
5
Replies

Cisco 1700 Series T1 Point to Point Change Clock Source

broomstar
Level 1
Level 1

So I am trying to change the clock source on my already setup cisco t1 point to point, but it wont allow me to. I have had many people tell me 10 different things that I have to do but no one seems to know how. I put in the command clock source internal, but it says its an invalid command. Any help would be much appreciated.                  

5 Replies 5

Karim.elwardany
Level 1
Level 1

have you tried IOS upgrade?

No I havent because I dont know which one to upgrade to nor do I know how really.

My current version is....

Cisco Internetwork Operating System Software
IOS (tm) C1700 Software (C1700-SV3Y-M), Version 12.2(8)YN, EARLY DEPLOYMENT RELE
ASE SOFTWARE (fc1)
Synched to technology version 12.2(11.2u)T
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Wed 30-Oct-02 10:22 by ealyon
Image text-base: 0x80008120, data-base: 0x80F47D4C

ROM: System Bootstrap, Version 12.2(1r)XE1, RELEASE SOFTWARE (fc1)
ROM: C1700 Software (C1700-SV3Y-M), Version 12.2(8)YN, EARLY DEPLOYMENT RELEASE
SOFTWARE (fc1)

pe-wen-01 uptime is 1 day, 18 hours, 19 minutes
System returned to ROM by reload
System restarted at 10:02:41 PDT Tue Jun 12 2012
System image file is "flash:c1700-sv3y-mz.122-8.YN.bin"

cisco 1751 (MPC860P) processor (revision 0x600) with 36864K/12288K bytes of memo
ry.
Processor board ID JAD06370AF0 (4055773928), with hardware revision 0000
MPC860P processor: part number 5, mask 2
Bridging software.
X.25 software, Version 3.0.0.
Primary Rate ISDN software, Version 1.1.
1 FastEthernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
2 Channelized T1/PRI port(s)
WIC T1-DSU
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

I appreciate the posted link however I cant see the bugtoolkit unfortunately. So if your saying its a bug within my IOS then I need to upgrade. Are there any easy steps to follow on how to do this, or any easy way to know what version to upgrade to?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: