Cisco 2960: "show lldp neighbors" cuts remote device ids (hostnames)

[enrico.frediani]

Hello everybody, when I type "show lldp neighbors" on my 2960, I have an output like this:

POLI-61A-192.168.100Gi1/0/25       120        B               Gi1/0/25

The first column represent the remote device ID, but it is cut to the first 20 chars only. Is there a way to see the whole string (that is greater than 20 chars and I cannot reduce it)?

thanks for help 

[omz · Accepted solution]

Hi 

you cannot chnage the column width in show lldp nei command.

does sh lldp nei [interface] [detail] show more than 20 characters?

[enrico.frediani]

sh lldp nei [interface] [detail] is quite right. I hoped to enlarge the DeviceID column ad so have a brief view, instead of giving a command for each interface and have a too detailed view. 

I will have to resign myself to the fact

thanks for useful help