Thanx for the reply.
I tried each step but it didnt work.
i have some queries to ask.
i set IP as 10.1.1.2 n what should be the subnet (255.0.0.0 or 255.255.255.244 this is what "set" command shows).
Which cable i should use (Straight/cross ) for PC (tftp server) and access point.
i connected using cross cable bt it was not showing connected. i.e. LED was not glowing.
Step 8 Press and hold MODE while you reconnect power to the access point.
Step 9 Hold the MODE button until the status LED turns red (approximately 20 to 30 seconds) and then release.
after this as you are saying it should be step 10 i.e.
Step 10 Wait until the access point reboots, as indicated by all LEDs turning green followed by the Status LED blinking green
but it is not restarting. showing 2 RED leds. i waited long for green to come bt....
den i manually restart it by removing power cable n repluged it.
wen i took console session it was showing following msg :
auto-negotiation takes 10000 milli-seconds to complete
ERROR: timeout waiting for auto-negotiation to complete
ERROR: fail to bring ethernet link up
The system has been encountered an error initializing
ethernet port. You may need to check hardware
The system is ignoring the error and continuing boot.
If you interrupt the system boot process, the following
commands will reinitialize ethernet, tftp, and finish
loading the operating system software:
The system is unable to boot automatically because there
are no bootable files to boot.
C1200 Boot Loader (C1200-BOOT-M) Version 12.3(2)JA4, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Compiled Mon 13-Jun-05 15:39 by ssearch
I think i made mistake somewhere.
plz suggest if you can.