cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1863
Views
0
Helpful
4
Replies

CISCO ASA 5555-X BVI Interface Creation

Slippy_Skin
Level 1
Level 1

Hi All,

 

Want to fresh install a 5555-x

So far via Terminal :

1. Reset device
config t
configure factory-default

 

2. Reboot device
Reload

 

3. Config

 

interface Management0/0
no shutdown
interface GigabitEthernet0/0
nameif outside
security-level 0
ip address dhcp setroute
no shutdown
interface bvi 1

 

The "interface bvi 1" line fails ?

ciscoasa(config-if)# interface bvi 1
^
ERROR: % Invalid input detected at '^' marker.

 

Any ideas ?

Cheers,

LM

 

4 Replies 4

marce1000
VIP
VIP

 

 - Might only work in transparent mode and or check this thread :

         https://www.techtutsonline.com/interface-configuration-in-cisco-asa-transparent-mode/

 M.



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !

Nice one, I will check it out, thanks.

 

Cheers,

LM

Morning Marce1000,

 

Well that kind of worked, that lets me add the line (from the config attached)

interface bvi 1

But then the next two commands:

nameif inside
and
security-level 100
fail.. ?

 

Also further down when I try:

 

interface GigabitEthernet0/5
security-level 100
no shutdown
bridge-group 1
nameif inside_5

 

I get


#ERROR: Cannot add more than 4 interfaces per group.

 

The full config as per the CISCO site https://www.cisco.com/c/en/us/td/docs/security/asa/quick_start/5500X/5500x_quick_start.html  is attached

 

 

>..

>nameif inside
>and
>security-level 100
>fail.. ?

  How do these commands fail and or which errors are displayed when those particular-configuration commands are tried ?

 M



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: