cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1010
Views
0
Helpful
4
Replies

Cisco common services integration into ACS 5.0

koeppend
Level 4
Level 4

Hi all

Has anyone here successfully integrated Cisco common services into ACS 5.0?

I have successfully done this with ACS 4.2 but I dont think CS understands the new way to connect to ACS 5.

I have already read the following guide, it basically fails when you click the apply button under AAA mode in CS to connect to the ACS server.

http://www.cisco.com/en/US/prod/collateral/netmgtsw/ps6504/ps6528/ps2425/prod_white_paper0900aecd80613f62.html

So I can see port 49 connects but CS cannot access the web interface to deploy its authorization sets.

-Tacacs+ Connectivity Reachable

-HTTP/HTTPS Connectivity Not Reachable

Protocol mismatch detected.

Ive tried both http and https, get same error

Any suggestions would be helpful.

Cheers all

Dale

1 Accepted Solution

Accepted Solutions

Joe Clarke
Cisco Employee
Cisco Employee

No, integration with ACS 5.0 is not possible, or will ever be possible. The API hooks to do integration are not available in ACS 5.0. They will be restored in 5.1, at which point support will be added to LMS.

View solution in original post

4 Replies 4

Joe Clarke
Cisco Employee
Cisco Employee

No, integration with ACS 5.0 is not possible, or will ever be possible. The API hooks to do integration are not available in ACS 5.0. They will be restored in 5.1, at which point support will be added to LMS.

Cheers JC

Thanks for the feed back.

Regards

Dale

JC,

Any idea when 5.1 will be appearing on the roadmap ?

Regards,

Dale

The dates I have say middle of November of this year for release, but that won't mean LMS will support it. LMS support will probably not be ready until summer of next year.

Review Cisco Networking for a $25 gift card