We have configured two Lightweight Access Points using a 3504 WLC. Both access points are connected to the WLC, and have been assigned IP addresses through DHCP from the WLC. Both also state they are providing the WLAN we created. Authentication for ...
Forum Posts
Hi all,Any help here is appreciated. in DCNM switches/ VDCs license state says ''switch model unknown '' When we try to assign I get this error-you selected a row that can't be licensed we believe License of DCNM is included in the package
When specifying a file path for our config archive, the standby and member switches reboot. While the active switch stays up, the other switches in the stack reboot as soon as the command is entered. If the command is not removed before the switches...
I'm experiencing 'request timeout' when trying to ping external destinations from my network. The issue occurs when ACLs are enabled on my router. It's perplexing as to why this happens. Any suggestions or insights on resolving this issue would be gr...
What have I tried?Once I connected the console cable to the router and my system, I checked that the USB port was available in my system and accessible.$ ls -l /dev/*USB* /dev/ttyUSB0 $ dmesg ... [22726.984409] usb 3-3: new full-speed USB device n...
Hello everyone. Our switch has expired. And I found 3 old model switches. Cisco SG2000-26, LINKSYS SGE2000 and a DELL PowerConnect 2824. We will use these 3 switches in our office for a temporary period. Then we will replace them with the latest CISC...
Hello,Cisco 3548 configured for ptp not working properly , The configuration is made as it is said in the document https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus3548/sw/system_mgmt/602/b_N3548_System_Management_Config_602A11/b_N3548_...
Discovery1_French.html
Resolved! EVE-NG MANAGEMENT CLOUD
Hi Guys. I have installed eve-ng on Hyper-V on Windows 11. I am trying to run multiple routers and FortiGate devices but have not been able to access the devices from my PC. I am using a bridged-adapter. My home network issues an IP address to my eve...
Hello everyone.How do I see Port-channel 1.700 loading like Port-channel1?3900-SPE100/K9#show interfaces po1 | i rateQueueing strategy: fifo5 minute input rate 12862000 bits/sec, 2569 packets/sec5 minute output rate 12802000 bits/sec, 2558 packets/se...
Hi I'm using buildin DHCP on FTD, but I need to find what hostname has DHCP client. Is there any way to find it on device? show dhcpd binding all command shows only ip address and MAC address.
Hey, I'm working on this project and could use some help. I'm trying to show that Quality of Service optimization for a network is way better than regular optimization. I'm using Cisco Packet Tracer to illustrate the network design before (no Quality...
So, I currently have an ‘ip access-list extended OUTSIDE-TO-INSIDE’ so if I am correct and there can only be one OUT-TO-IN list, I assume I’ll have to add these to that.Would this be correct; ip access-list extended OUTSIDE-TO-INSIDE 70 permit tcp ...
So my CISCO 3925 ROUTER has IOS 15.7(3)M6 I can only find Documentation for 15.3(3) and 15.6(3)... they are Basically all 15.x M&T Versions...I guess my question: Is there going to be much Difference in the Documentation that I use??
Hi all, need help in figuring out how when any user runs clear arp-cache, the command doesn't actually execute. Its easy to do it with IOS but with XR I am having trouble coming up with a script. Any ideas? XR doesn't have privilege commands and ...
