Cisco Firepower FTD SNMP information for routing protocols

[oizetbegovic]

Hello,

I'm setting up SNMP monitoring of Cisco FTD 1140 and I need some help. Is there a MIB which contains information about routing protocols (OSPF, EIGRP, BGP) configured on FTD? The same goes for power supply state.

Any advice is appreciated!

[balaji.bandi]

check below URL for help :

https://www.cisco.com/c/en/us/support/docs/ip/simple-network-management-protocol-snmp/213971-configure-snmp-on-firepower-ngfw-applian.html

https://www.cisco.com/c/en/us/products/collateral/security/firepower-ngfw/white-paper-c11-741739.html

[oizetbegovic]

Hi,

I'm aware of these documents but there is no trace of routing protocol monitoring in them. I've already searched lots of Cisco documents but couldn't find anything useful. That's why I've turned to community to check.

[balaji.bandi]

I will do some test on this with SNMP walk against FTD - configuring Routing IGP in it.

mean time you can download if you have access to MIB and try

FXOS MIBs for Firepower 1000/2100 series - fxos-mibs.2.8.1.129.zip

[oizetbegovic]

Hi,

have you been able to find some information?

[balaji.bandi]

I am afraid this will push back to next year --- not got a chance due to pandemic...