CISCO LMS 4.2 BASELINE TEMPLATE ERROR

[tirabor01]

Hello Team,

I Kindly need your support.

I kindly require your assistance in creating a baseline template using Cisco Prime LMS.

The configurations I used for the CLI commands on the Compliance Block can be seen in the attached.

I have been getting an error stating :  Compliance Block CLI commands should start with a'+' or'-' or'#' after which I applied the symbols.

I would appreciate a technical assistance to help review the configs in the attached.

Please do respond swiftly as it is extremely urgent.

Regards,

Tioluwani Irabor.

CSCO11624940.

[luke.k.mester]

1) Remove the line breaks after every line

2) Match a single string, value "string" like this:

+ enable secret 5 [#.*#]

3) Match a value "string string string" value like this:

+ [#banner motd .*#]

4) It is very difficult to match a multi line command correctly.