Cisco Network Assistant - Health Monitor Not Showing Bandwidth Utilization

[Draven1231]

Hello,

Ive setup a new network with 3x 2960 and 2x 3650 switches, trying to view the bandwidth utilization per switch in cisco network assistant in the health monitor unfortunatly it show 0%. I know there is alot of traffic passing through the switches, the other monitors are working correctly (temp, ram and cpu). Is there any special settings that are needed in the switch?

Thanks

[rajevasu]

Hi Tequila,

Could you please execute "show controllers utilization" in your 3750 device and provide the output, so that we can able to clarify your doubt.

Thanks & Regards,

Rajesh Vasudevan