Network Management

I have a bunch of C9200 and C9300 switches. Call-Home profile is configured with "destination transport-method http". A Google search seems to indicate I should be able to change that to "destination transport-method https" but when I try to I get a ...

Hello everyone, I would like to secure my router using Netconf with an access-list. Documentation says: netconf-yang ssh {{ipv4 | ipv6 }access-list name access-list-name} | port port-number} But on my router there is no such option: router#netconf-ya...

Hello   So currently I have a DSL MODEM - FPR1010 - SG350XG. My Internet is DSL w/ 8 static IP's and the FPR does the PPPoE and is connected to the SG350XG with routing back towards the Internet... On the SG350XG I have 6 vlans [each single vlan is a...

Hi all,there is a problem that we try to solve since some days.On an WLC 5520 with a management IP-address say 10.0.0.1 I can access the GUI from network A (172.16.0.0/24) but not from network B (10.3.0.0/24).From both networks A and B I can ping the...

how to get the OEM letter. kindly help with this.

I'm trying to find a regular expression that works with a show command (such as show ip bgp summary) and only displays the IP addresses in the output, excluding all the other characters. I came up with the following:show ip bgp summary | include ^[0-...

Hi Team.Currently, in EPNM8.1.1 version, after configuring the EPL service for NCS5504 and ASR903 equipment, a failure occurs when looking up LSP OAM. I am wondering if this is a problem with the software XR and XE versions or if it is supported.NCS5...

Hi,I'm trying to do this exercise, i've already configured the ips , the dhcp server and the ssh to the switchI still not find the way to implement the NAT on the gateway, can someone help to configure that?I give you the exercise to help me better.T...

Dears,        I have a customer who has an issue with voice between two branches; the WAN link is utilized at peak hours of the day.        I need a full QOS conf end-to-end from the access switch to the WAN router        Does anyone have a document ...

Is there anyway I can get email alerts for BGP events especially when an adjacency goes down? I need help configuring it using either EEM or Cisco Prime.

This is after deleting the previously stored key from/home/myid/.ssh/known_hosts.debug1: sending SSH2_MSG_KEXDH_INITdebug1: expecting SSH2_MSG_KEXDH_REPLYdebug3: check_host_in_hostfile: filename /home/myid/.ssh/known_hostsdebug3: check_host_in_hostfi...

Hi.We have remote location with ASA and in datacenter we have Palo Alto with internet break out.I might be dumb but, how do I configure the ASA to have whole traffic being sent through the tunnel?How should the routing be configured on ASA? ... and c...