cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1239
Views
0
Helpful
2
Replies
girish_gavandi
Beginner

Cisco Prime 1.2 device interface alarms

Hello All,

I am working on Cisco Prime Infrastructure 1.2.1.012. I have enabled prime to report interface up and down messages.

But I am seeing some strange messages such as below,

Alarm Condition:Link down

Message: Port '{0}' is up on device '{1}'.

This is happening for some of the interfaces of the switch. For the same switch if there is any interface activity I can see alram message as,

Message: Port 'GigabitEthernet0/43' is up on device '10.104.xx.xx'

which is good and undestandable. Why the interface name is shown as {0}?

Any suggestions would be much appreciated.

Regards,

Girish

2 REPLIES 2
girish_gavandi
Beginner

Just found the solution to the problem!

Bug ID: CSCuf55719, Incomplete link down detection: Port '{0}' is down on device '{1}'.

It seems this issue will be fixed in PI 2.0.

Regards,

Apparently just by doing "Sync" device its working perfectly.

Predrag Petrovic

Predrag Petrovic