Cisco Prime 3.1 Chassis view missing for a number of devices.

[Farooq Muhammad]

Hello,

Cisco PI 3.1 chassis view is missing for a number of devices such as 4500x, 6500E and some other models , even with the device pack 10 installed.

Is something wrong with my server or these has not been provisioned yet.

Regards,

Farooq

[Pari Thiagasundaram]

You need to check the device packs to see the OID that you have in your network. Goto: http://www.cisco.com/c/dam/en/us/td/docs/net_mgmt/prime/infrastructure/3-1/release/notes/pi31-device-pack-readme.pdf

And on the first page, click on "Viewing New Devices Supported". Verify if your device is there on that list.

Oh by the way, device pack 11 was out today :)

[Marvin Rhoads]

Chassis view is not included for many products. 

Cisco has backed off from commiiting to that feature across the board after their experience with how much trouble it was to support CiscoView in LMS and predecessor products.

As noted in the Device Pack XLS file, the following features are supported for switches:

Cisco Switches (IOS) : Supported Features
Switches and Hubs
Configuration			Inventory
Access Control List Management			Spanning Tree Protocol
Controller Interfaces Management			VLAN Information
Etherchannel Management			Performance Monitoring
Interface Management			Device Availability
Inventory			QoS
Flash Information			CPU
IP Table			Interface
Image Information			Interface Availability
Interface details			Memory
Memory Pool Information			Topology
Physical Inventory			CDP Neighbor Discovery
Power Supply and Fan Status			LLDP Neighbor Discovery