04-13-2021 08:26 AM
Hi All,
I just installed Cisco Prime version 3.8 for a campus network. What I would now like to do is remove some ports (those connected to office PCs and / or telephones) from alarm monitoring. Now I get a lot of "link down" alerts that I don't care to monitor. Following other discussions I created a "Port Group" with only the UpLink ports later in Monitor-Monitor Policies I added a policies with the new group disabling the main Policies (Link & Trunk Ports).
But I still get "link down" alerts from other interfaces as well.
Do you have any suggestions?
Thanks
04-13-2021 09:02 AM
- You may be able to change the severity level (or category) of these alerts.
M.
04-13-2021 11:13 PM
@marce1000 wrote:
- You may be able to change the severity level (or category) of these alerts.
M.
Ok, sorry may you tell me how to do this?
Thanks.
04-13-2021 11:59 PM
- Have a look at this document :
M.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: